Thingiverse
Manual Bed Leveler
por Goulet
2
Descargas
2
Likes
0
Makes
Resize this to fit about the size of your print bed leave about an inch or two from each side and print with no bottom layer and watch your print head to make sure it is about the same level around each corner of the print. This is for manual hot bed adjustments like in the Anet A8 where you have to adjust springs.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
