Thingiverse
Manual Feeders: Complete System
par sungdzda
103
Téléchargements
47
Likes
0
Makes
**A BASE**. Please use M3*8 bolts, spring washers and hex nuts to fix rails to the base, to make the system portable. IPT included.
**HIGHER VERSIONS OF ALL 3 CARTRIDGES**. Heights increased by 5mm. SLDPRT included.
**CARTRIDGE PRINTING DIRECTIONS**
Print flat. No support. Fan on high. Solid infill. Finest settings. Clean up with xacto knife.
Manual Feeders: The Complete System is printable on a 200*200 format. Split models as needed.
Do not tighten the rail screws with excessive force. Otherwise you may squash or crack prints. Did I mention spring washers?
Use pre cut stickers to label. You can buy those in sheets of 500. If you have a label maker, that's fine.
Credits to the awesome people who published the original models.
**FURTHER WORK NEEDED** Improve the fitting.
**HIGHER VERSIONS OF ALL 3 CARTRIDGES**. Heights increased by 5mm. SLDPRT included.
**CARTRIDGE PRINTING DIRECTIONS**
Print flat. No support. Fan on high. Solid infill. Finest settings. Clean up with xacto knife.
Manual Feeders: The Complete System is printable on a 200*200 format. Split models as needed.
Do not tighten the rail screws with excessive force. Otherwise you may squash or crack prints. Did I mention spring washers?
Use pre cut stickers to label. You can buy those in sheets of 500. If you have a label maker, that's fine.
Credits to the awesome people who published the original models.
**FURTHER WORK NEEDED** Improve the fitting.
sungdzda publie également sur
1 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
