Thingiverse
Manual OTF Knife Ver2
von R88_tanker
10
Downloads
10
Likes
0
Makes
NOT FOR USE AS WEAPON
Manual OTF knife.
print bearing rig at 0.12 resolution.
locking mech might need some sanding down after printing as the fit can be quite tight.
Requires 3 3x8x3 mm (MR83-ZZ) Bearings
1 4mm wide barrel sex nut
1 5mm wide barrel sex nut
Both barrel sex nuts should be roughly 13-14mm long
Manual OTF knife.
print bearing rig at 0.12 resolution.
locking mech might need some sanding down after printing as the fit can be quite tight.
Requires 3 3x8x3 mm (MR83-ZZ) Bearings
1 4mm wide barrel sex nut
1 5mm wide barrel sex nut
Both barrel sex nuts should be roughly 13-14mm long
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
