Manual Spool Winder

There are many great spool rewinders out there, however I wanted something a little more simple and this is about as simple as it gets. The winder handle fits on to the standard Bambu Lab spools, using two of the filament retention holes to secure the handle. It can then be put over a suitable tube to act as an axel. In my case I am used an old spool holder from an old Ender machine with the bevel at one end cut off to allow the handle to slide over cleanly. The central hole can be modified in the slicer for your available options. I am unable to verify compatibility with A1 or A1 mini. If someone is able to up load a profile for those printers that would be great. Boost MeThese are greatly appreciated and will be put to good use. Thank you in advance.