Thingiverse
Manuka Gyroscope Bumper
by DieterMeier
1
Downloads
0
Likes
0
Makes
The bumper broke and I designed it a little bit thicker.
2mm longer screws are needed.
You only need support in the middle of the arc - I used a support enforcer 25x25mm in prusaslicer.
The last layers look better, if the layer hight is down to 0.07mm.
2mm longer screws are needed.
You only need support in the middle of the arc - I used a support enforcer 25x25mm in prusaslicer.
The last layers look better, if the layer hight is down to 0.07mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
