Maple Syrup Tap

Here's my tap for making maple syrup. These suckers get expensive to buy a few bucks at a box store, now we can print them for pennies per piece.

If you have any questions or feedback leave me comment.
*If you like my design please tip me a few meters of filament, so I can keep on printing. Thanks you.*

**Twist Drill Size:** 7/16 in or 11 mm
**Drill Depth:** 1 1/2 in or 40 mm
**When to Tap:** February to mid March
**Min Tree Diameter:** Around 18 in or 45 cm
I used 2mm spring steel wire to hole the jug, but any wire will do. Like a coat hanger, e.g. Mine held 18 LBS or 8 KG with no problems.
*Remember to fill holes with tar when done, to keep bugs out e.g.*



> **Updates**
>>**Version 1.2**
>>The STL mesh is higher quality.
>
>>**Version 1.1**
>>Added more taper to the tap.
>
>>**Version 1.0**
>>Initial release