Maplestory Slime - Squishy TPU

A classic slime from Maplestory in squishy TPU This is a difficult print to get right!This was my first time printing TPU and I did a lot of experiments to try and print the perfect slime (see slime graveyard below)My goal was to print a hollow squishy slime and it came out pretty good, but you might need to experiment with the settings. The most important things to consider are:Wall loops: I set it to 3 which I found to be a good balance of strength and squishiness. Increasing wall loops will make it print better at the tip but it will be harder to squish. Lower numbers increase squishiness but will likely result in print failures.Size: I printed one larger and the final print quality seemed to be better, but I wanted to keep it small. Consider increasing sizeBottom shell layers: This is a weird setting. I thought increasing it would just increase the bottom layer, but it actually adds extra wall loops up to some seemingly random layer about a quarter of the way up. That's why I s