Thingiverse
Marantz amp support pillar
door MarkMLl
0
Downloads
0
Likes
0
Makes
This is a pillar to sit behind a Marantz EQ551 equaliser and support a Marantz PM-55SE or similar amplifier. It includes a threaded jack to allow the height to be adjusted so that a minimal-sized turntable such as one of the smaller Technics is stable on top of the overall stack.
They are intended to be used in pairs.
The bottom part- the pillar- has apertures positioned and sized to clear the equaliser's signal and power cables, and a recess for a male-threaded capital Superglued in place.
The top part- the female-threaded lintel- is recessed to suit the amplifier's foot.
The male-threaded capital is a separate subassembly. This is in part so that its length can be easily adjusted, but also so that it can be printed with more infill etc. and wound in-and-out of the lintel a few times to smooth the surface of the print.
In order to assist initial fitting, the capital has a Torx recess. However once glued to the pillar this will be hidden.
They are intended to be used in pairs.
The bottom part- the pillar- has apertures positioned and sized to clear the equaliser's signal and power cables, and a recess for a male-threaded capital Superglued in place.
The top part- the female-threaded lintel- is recessed to suit the amplifier's foot.
The male-threaded capital is a separate subassembly. This is in part so that its length can be easily adjusted, but also so that it can be printed with more infill etc. and wound in-and-out of the lintel a few times to smooth the surface of the print.
In order to assist initial fitting, the capital has a Torx recess. However once glued to the pillar this will be hidden.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
