Thingiverse
Marco's Dimensional Scissors
von Rainbow_Science
40
Downloads
45
Likes
0
Makes
The blades and handles are available separately if you have a small printer (and do not require supports this way)
You'll need to print:
2x Blade and 2x Handle, or 2x Full Scissor
2x Flame Plate
1x Pivot Part 1
1x Pivot Part 2
When Assembling, the pivot points go through the blades and glue together. The flame plates cover the pivot points, but be careful not to glue the pivot point to the flame plates. There should be just enough room to glue the plates to the blades without getting glue on the pivot point.
The separated blade and handle version can be printed on a printer with a 120mm x 120mm build volume.
You'll need to print:
2x Blade and 2x Handle, or 2x Full Scissor
2x Flame Plate
1x Pivot Part 1
1x Pivot Part 2
When Assembling, the pivot points go through the blades and glue together. The flame plates cover the pivot points, but be careful not to glue the pivot point to the flame plates. There should be just enough room to glue the plates to the blades without getting glue on the pivot point.
The separated blade and handle version can be printed on a printer with a 120mm x 120mm build volume.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
