MARGIE FAN

Another fan. Is an experiment and fit on the Noctua 12x25 as previous.

Printed in ESUN PLA-st on a FLSUN SR (19 grams in total)

You have to open the two stl files and put all to X:0 Y:0 Z:0 to align custom support.
On the left panel, (after selected the support), you have to select and set the values to customize the flow and the speed (reference images and PDF images). Obviously if you think to use other better settings, you are free to do as you want. I send all to you only as reference, in case you don't want to spend too much time solving print problems.
Important is the Z-hop on 0.5mm at least and the "external to internal". In my case it did make the print possible without detaching the print for collisions.

Printed easily in two hours with my settings, but i think with 0.12mm height (achieved in dynamic as in setting) can be better too, for the top part.
Custom supports are very easy to take off.

Suggestion are well accepted as always.

Cheers