Mario's Last Descent

This idea started from something else, but once I had the eureka moment, I knew it had to be done! The single brick went through multiple variations, including magnets, hinges, and all sorts of locks, but in the end, the simplest design worked best. The tolerance between the pipe and the screw is quite loose, so you shouldn't have any problems with it sliding down smoothly. Once printed you may need to screw it in and out several times to "loosen" it up. One thing to watch out for is the material you use—for example, matte, wood, and sparkly filaments can cause some issues due to friction, so keep that in mind. No supports are required for any of the parts. Make sure you print the Pipe with the thick part facing down (Updated orientation from previous version) If the Pipe Does not slide: Make sure you are not using PLA with friction issues like sparky, galaxy and wood filaments.Make sure your seam is not causing the issue - try changing positionPush the pipe in and out LOTS of time