MakerWorld
Sport & Outdoors
Go to Model
Marlboro Golf Tee Case
157
Downloads
80
Likes
121
Makes
This is a Marlboro inspired golf tee case that fits 8 standard width tees of all lengths. As seen in the last photo, the hinge is created by inserting a piece of filament all the way through the base and lid, and then melting the filament piece to the outside holes on both sides. I used a 3D pen to weld it shut but you can also use a lighter and heat up the hex key/allen wrench provided in the Bambu maintenance kits. In order to print with minimal supports, the face plate slides into the base. The print is not perfect in terms of staying closed but it gets the job done if isn't shaken too much and does remain closed upside down.I used a 0.4 mm nozzle for this, any other nozzle size may result in loose or tight tolerances.Thank You For Supporting My Model! 😊
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
