Marmo Over-Engineered 3d Printer Control Box - Tevo

What I have designed here is an over-engineered control box that will hold an S-300-12 PSU, RaspberryPi (via separately printed bumper and then glued in place), 1 hot bed Mosfet, the MKS 1.4 board, a LM2596 Buck Converter and, the top cover of the MKS board that holds the fan. Yes, I know... ANOTHER control board case... This is my FIRST ever designed part and I hope it works for you.

This case will hold the PSU tight from the top and bottom and is designed to vent to the side through the spiral cutout. Cooling is passive but the PSU fan draws enough air in from the front that heat should not be an issue. If it is, the holes in the front are designed to fit a 40mm fan using bolts and nuts.

Parts should be printed FLAT with no support. Parts that need support have them built in as tear-away tabs that are easy to snap off and will break clean.

The top forward panel has two holes to place emergency stop button and keys. It is printed thick to support the possible pressing of but