Slicer Discord
Mars Base – 3D-Druckmodell von Thingiverse Thingiverse

Mars Base

von mtomalty
5 Downloads
5 Likes
0 Makes
Zum Modell
This is the design for the Mars Base Challenge, it is designed as a box so you can see the set up above and below ground.

The base is built 5 meters underground to protect the astronauts from radiation. There are 4 main areas; the living quarters, laboratories and green house, the water pump and storage and the workshop.

The water pump is a drill which dills into the ice under mars surface and melt it for drinking water. The shop is for maintenance as well as a place to store the rover to keep it safe from the cold temperatures of Mars.

On the surface you will see the main entrance which connects to the 3 main partitions of the base and the entrance to the shop - which is an elevator - on the other side. There is solar panels set up for energy and the base can use the gases from the planet for extra power. Mars has quite a bit of carbon dioxide and nitrogen in its atmosphere which can be extracted through the vents in the main entrance's roof to be mixed into breathable air.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen