Marshal Amplifier Key Rack

Marshal Amplifier model meant to be hung on wall and hold keys using a quarter inch male end on the keyring and female on the amp.

For printing the body I recommend using the Fuzzy Skin setting in Cura with Skin thickness: 0.3mm and 6 mm^-1 density outside only.

For hanging on the wall use drywall anchors with #6 x ~1" screws (round head).

For the Headphone jacks any generic female quarter inch should work and to make the keyrings I just glued some 22 gauge wire into the 3.5mm hole of a 3.5mm to quarter inch adapter.

When printing the 'Mesh' and the Plate you'll need to manually stop the print and swap filaments to get the correct colour or use AMS etc.

No supports needed.

Canadian made :)