Marui Samurai Tyres

Now that tyres for the Samurai are rarer than hen's teeth, I decided to try and print some.
I found that if you print this, laid on it's side, it can be printed without infill, and give a fairly soft, and useable tyre.
I printed it with:
1.2mm thick top & bottom
1.0mm wall thickness
0.15mm layer height
If you've never printed with TPU, the key to it is slowing your printer RIGHT down...
I normally print at 40 - 50mm/second.
With TPU I found the best results were at a maximum of 15mm/second.