Thingiverse
Mask Channel maker
par Dixon3dprinting
31
Téléchargements
25
Likes
0
Makes
Added New smaller Variants
needle is 1.5mm thick
then 5mm and 10mm
just saw a video from my friend johannah, showing a design that makes a channel in your mask so you can add a continuous cord, bias tape fishing line or w.e
this mask design will not sit on the ears
***i dont have the plans for the design its the same as standard designs but you dont sew in the elastic.cord/ribbon/bias ** you leave a channel this is a guide to help you leave that open
i created a tool that is basically just a thicker knitting needle (that would work just the same)
i have single units then i have the 5pks the 5 pks are connected with a .4 thick pieces
LAYER HEIGHT print in .1 .2 or .4 only
needle is 1.5mm thick
then 5mm and 10mm
just saw a video from my friend johannah, showing a design that makes a channel in your mask so you can add a continuous cord, bias tape fishing line or w.e
this mask design will not sit on the ears
***i dont have the plans for the design its the same as standard designs but you dont sew in the elastic.cord/ribbon/bias ** you leave a channel this is a guide to help you leave that open
i created a tool that is basically just a thicker knitting needle (that would work just the same)
i have single units then i have the 5pks the 5 pks are connected with a .4 thick pieces
LAYER HEIGHT print in .1 .2 or .4 only
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
