Thingiverse
Mason jar Bubbler
von Berbexe
0
Downloads
2
Likes
0
Makes
Designed to replace the lid that seals the jar (NOT THE THREADED LID PART) the threaded lid section then gets put over the mouthpiece and twisted on the jar. (Smallmouth)
From the orientation it arrives in your slicer, I recommend rotating it 65° on it's X axis.
supports are needed outside, but not inside the tubes.
MK1
From the orientation it arrives in your slicer, I recommend rotating it 65° on it's X axis.
supports are needed outside, but not inside the tubes.
MK1
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
