Thingiverse
Massage Ball Roller
von Ultimatebucky0
14
Downloads
16
Likes
0
Makes
This is a roller to massage muscles when they are sore.
It prints in three parts.
The base and middle piece can be printed at relatively course quality but I suggest printing the ball in a fine layer height.
Once they are printed put the ball into the middle piece and push on the base. Mine fit in with friction but you may need to use some glue.
The ball should be sanded a little and then when you assemble it use the device quickly so that you build up friction and dissolve the layer lines
It prints in three parts.
The base and middle piece can be printed at relatively course quality but I suggest printing the ball in a fine layer height.
Once they are printed put the ball into the middle piece and push on the base. Mine fit in with friction but you may need to use some glue.
The ball should be sanded a little and then when you assemble it use the device quickly so that you build up friction and dissolve the layer lines
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
