Thingiverse
Massage Roller Ball
von wyliebutler
76
Downloads
73
Likes
0
Makes
My version of a massage roller ball. This was designed with Design Spark Mechanical 4.0 and printed on a SainSmart Ender 3. The body and ball were printed in CCTREE PLA while the grip was printed in SainSmart PTU.
Body and ball printed at 205C at a 50mm/sec, 2mm layer height.
Grip was printed at 205C at 15mm/sec, 2 mm layer height.
You will require 2 skateboard bearings 22mm X 7mm. (8mm bore).
I used Cyanocrylate and insta-set accelerator to glue the parts.
Body and ball printed at 205C at a 50mm/sec, 2mm layer height.
Grip was printed at 205C at 15mm/sec, 2 mm layer height.
You will require 2 skateboard bearings 22mm X 7mm. (8mm bore).
I used Cyanocrylate and insta-set accelerator to glue the parts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
