Massive Rope Box

par JamesThePrinter · Organizers

155 Téléchargements

95 Likes

27 Makes

This massive model will (almost) max out your build volume!!! You will have a 1mm buffer on all sides in X and Y. Unless you have changed certain settings, you actual Z height maxes out at 250mm - this model comes within 2mm of that max height! The rounded corners allow this enormous model to avoid the Exclusion Zone on P1/X1 printers. If you like this rope design, check out the rest of my rope models here. Print SettingsI reduced infill for most of the print, but kept a higher amount in the base to get a better finish. FAQQ: Should I remove the purge line(s) before printing starts? A: I recommend leaving it, but that's up to you. If you choose not to remove it, the purge line can easily be removed after the print is complete. If you want to remove it, be quick! The print starts in the front, so you have very little time!!! The following filaments were used in the pictures above:Bambu Lab Basic Bright Green PLA

big bigmodel box container fullbuildplate huge hugemodel jamestheprinter large largest massive maxedout maxedoutbuildplate maxout rope ropebox ropecontainer sizematters weave woven

Catégorie

Organizers

Source

MakerWorld

Publié

28.02.2025