Master mudguard v3 _ EMA_linkage compatible

I made a v3 of the mudguard (EUCzero_fender_holder) to fit the EMA-linkage (carbon - made by Tomasello)

The mudguard needs to be closer to the tire for this linkage, so I made a 25 degree bend.
The plastic flap now also snaps in place much easier and locks better, but a tad of glue or double sided tape can be used to really lock it in place.

You need a thin plastic sheet in size 10cm x 20cm or similar for the mudflat itself. The print is the holder/mount for the mudguard to fit on the metal fender already on your Master/T4/ex30.
You can also use a cut from a yoga mat, pet bottle, lid from a lunch box or anything thing and easy to cut water resistance material. If you cut it long enough to lay on the kickstand it can be quite soft material as well.

Print in TPU (30 - 40 gram)
Thick walls (minimum 2,4mm)
infill: I used 10%. With thick walls the infill is not important on this one.
Print standing with the thickest part down on the building plate.
No supports

https://www.