Thingiverse
Master spool (refill) from eono spool
di toastfr35
2
Download
2
Likes
1
Makes
This is a kit to convert a 'eono' filament spool to a refillable spool.
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle
toastfr35 pubblica anche su
29 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
