Masterforce (Menards) Track Saw Track Square

Two versions of a slide-on track square for the 6 ½" Masterforce Track Saw from Menards. I printed these in a relatively cold shop, uncovered, with a 65/60C Bed Temp. The face that rests on the bed will almost certainly deform when the print cools. I didn't have any issues with adhesion, but the ends of the long faces did curl up slightly. I was able to trim a little of the outside layers with the saw, after printing, and now it sits square to the plywood sheets. Will likely add a profile that extends from the bottom of the track a bit more for quicker setup while cutting but I haven't had an issue with the thin contact area along the square. One version fully encloses the end of the track, like an end cap, but limits how close to the edge you can start the cut unless you make an initial cut through the print. The second version should slide on and off just as easily but should allow the saw to pass by easily, no matter how far up it is on the track (some testing and adjust