Mastertronic Essentials Nozzle Cleaning Bath

Mastertronic Essentials (aka Mastertronic ESS, MTE) Nozzle Cleaning BathUsed to help easily clean the reagent nozzles weekly. This model clips into the nozzle head securely, bathing the nozzle with RO (or vinegar). Recommend printing in PETG due to its tolerance to acids. A 0.16mm layer height or finer is suggested. Requires supports. NB: it is very important to remember to remove the support material inside the two tiny slots on the inside of the bath (back end of the bath, closest to the hand hold). These slip over the small ‘feet’ of the nozzle assembly (white part). They only protrude by 2mm, so these slots are very important. Instructions for Use:Fill with ~10mL RODI (or vinegar). This is the same as filling up to the level of the top of the steps inside the bath.To install the nozzle cleaning bath, gently slide the side wings of the bath rearwards along the top of the metal bracket just above the droplet sensor.The top of the bath will skirt just underneath the nozzles, and then