Thingiverse
Match Shooter
von ShadowJak
5
Downloads
4
Likes
0
Makes
Probably best to print the body with the flat part of the handle facing down. The slider needs no supports.
You'll need to figure out the right number of elastics to use and the right width of the striking surfaces to get the wooden match to light.
Use at your own risk. If you catch yourself, someone else, or something else on fire, you only have yourself to blame.
The original model suggests using 100% infill on the slider and 75% on the body which are bad ideas. Not sure why he suggested that. I used 20% infill on both with PLA and it is fine.
You'll need to figure out the right number of elastics to use and the right width of the striking surfaces to get the wooden match to light.
Use at your own risk. If you catch yourself, someone else, or something else on fire, you only have yourself to blame.
The original model suggests using 100% infill on the slider and 75% on the body which are bad ideas. Not sure why he suggested that. I used 20% infill on both with PLA and it is fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
