Thingiverse
MATCH UP 4DSP stand
0
Downloads
0
Likes
0
Makes
Stand to present the MATCH UP 4DSP.
The holder can be printed from any material. No supports are necessary when the model is placed on the build plate with the foot facing down. A layer height of approx. 0.15mm is recommended. By using threaded inerts for M3, it is possible to mount Magnets with a diameter of 17 mm and a height of 5.5 mm.
The holder can be printed from any material. No supports are necessary when the model is placed on the build plate with the foot facing down. A layer height of approx. 0.15mm is recommended. By using threaded inerts for M3, it is possible to mount Magnets with a diameter of 17 mm and a height of 5.5 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
