Matrix Core from Deep Rock Galactic

This is a Matrix Core from the game Deep Rock Galactic. I modeled it based on a few rough reference photos and it is fully 3D printed. It has screw on dials so that the colour of the buttons can be changed. The Overclock image is a printed and laminated piece of paper that slots in on the side and is held in place by a slight overhang around the screen. There is a storage compartment in the back that can fit many additional OCs that you can print to swap out to any, as well as the additional dials.

The core prints in a number of pieces that i will go over the setting i recomend using:

The top piece which is the largest is the most important to print correctly. I used 0.2mm and 20% infill and printed it with the screen facing down. I used the "supports everywhere" feature on Prusa Slicer which i recomend. It is important that the screen slit, and notches for the back lid, as well as the screw and pin holes print correctly.

The bottom piece with the 3 dials i printed at 0.2mm, 2