Slicer Discord
Matroesjka chess – 3D-Druckmodell von Thingiverse Thingiverse

Matroesjka chess

48 Downloads
38 Likes
0 Makes
Zum Modell
Matroesjka Chess, a chess set where the pieces stack and slide inside each other covered by the King. The King's height is 108 mm and a complete set slided together measures 36 x 72 x 110 mm.

The pieces are designed with a close eye on the traditional chess pieces looking for a compact set with minimal material use, mind you wall thickness is just 0,75 mm.

Attention. There is a small indent in the base of the king which should face the centre of the lid when sliding the base over the lower ring.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
110 mm (Mittel)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen