mATX bracket for extended 10inch rack

This micro-ATX bracket was designed for my LabRax build, but during fitment validation I realized that a standard LabRax rack does not provide enough depth for proper installation. As a result, this part should be considered compatible only with an extended-depth LabRax configuration, or with a rack that has been modified to provide additional clearance. Please note that this is not a direct drop-in part for a stock LabRax frame. Before printing, I strongly recommend verifying your rack depth, motherboard position, mounting clearances, and any interference points with surrounding components. Depending on your hardware layout, additional adjustments may be required. This model was created to solve a specific mounting requirement, so tolerances and final fit may vary slightly depending on printer calibration, material choice, and the exact dimensions of your setup. If you test it, improve it, or adapt it to a stock-depth version, I would really appreciate your feedback. Comments, fitment