Thingiverse
Mavic 2 Extension Legs
di mjhall29
38
Download
16
Likes
1
Makes
A set of extension Legs for the DJI Mavic 2.
They will give circa 52mm extra height. keep mavic out of the wet grass.
The rear legs have holes for forward facing lights (as in pictures).
Rear legs need to be clipped over the far end of the arm closest to the motor then slid into place as in photos.
it is important that the rear legs are fitted as shown as the clip is shaped.
20-12-18
I Have added some better photos.
Also added a modified front leg that can be printed with flexible filament. I used some TPU rated at 94A to take a bit of the landing force. back legs do not work out of flexible filament.
Front works and fits very well.
They will give circa 52mm extra height. keep mavic out of the wet grass.
The rear legs have holes for forward facing lights (as in pictures).
Rear legs need to be clipped over the far end of the arm closest to the motor then slid into place as in photos.
it is important that the rear legs are fitted as shown as the clip is shaped.
20-12-18
I Have added some better photos.
Also added a modified front leg that can be printed with flexible filament. I used some TPU rated at 94A to take a bit of the landing force. back legs do not work out of flexible filament.
Front works and fits very well.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!