Thingiverse
Mavic Air Compass Calibrator
von Mike-vom-Mars
37
Downloads
23
Likes
0
Makes
###MAVIC AIR COMPASS CALIBRATOR
- Allows calibration with one hand
- No danger to drop your Mavic Air
- Easy to print
- Small and portable
Video: https://youtu.be/12SAhi3XDlM
The compass calibration of the Mavic Air is an annoying process: you need both hands and are constantly afraid to drop it. So I created a little helper: with this easy-to-print, turntable-like tool, calibration is done in seconds, with just one hand and without danger of accidentally dropping it.
###Recommended Print Settings:
- 0.1 - 0.3mm layer height
- Wall thickness: 1mm
- Line thickness: 0.48mm
- Wall line width: 0.48mm
- Flow: 105%
- 15-20% infill
- Allows calibration with one hand
- No danger to drop your Mavic Air
- Easy to print
- Small and portable
Video: https://youtu.be/12SAhi3XDlM
The compass calibration of the Mavic Air is an annoying process: you need both hands and are constantly afraid to drop it. So I created a little helper: with this easy-to-print, turntable-like tool, calibration is done in seconds, with just one hand and without danger of accidentally dropping it.
###Recommended Print Settings:
- 0.1 - 0.3mm layer height
- Wall thickness: 1mm
- Line thickness: 0.48mm
- Wall line width: 0.48mm
- Flow: 105%
- 15-20% infill
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
