Mavic Pro DIY Filter Holder!

These are two versions of gel filter holders for the DJI Mavic Pro drone, as the idea is to cut a piece(s) of optical gel and insert it inside the holder and then place it over (carefully!) the camera. I have had mixed results with it passing the gimbal start up test so simply insert (carefully!) after start-up. I initially created this experiment with IR imaging on the Mavic using Congo-Blue Gel filters (see here: https://amzn.to/2O0bd1G) stacked 4 deep to act as an NIR filter. In addition, you can use other gel filters for additional effects so it is limited only by your imagination!

**Note:** there are two designs, one solid and the second with a notch in the side to allow the camera to move more fully to the left (when looking at it). Yet I still have not perfect a perfect gimbal "pass" so I have been simply installing (carefully!) after initialization.

**Major Favor:** if you make one of these please post the Make and share it with the community :-) .

Also, please