Thingiverse
Mavic skids v1.2
door Craftysdc
52
Downloads
27
Likes
0
Makes
Remix of the v1.1 skid for the Mavic pro, the original doesn't remove once it's on so I made it removable but still won't cover the sensors underneath. Approx 30mm or 1.2inch lift.
May get an update that fits a little nicer underneath, the current version is a little loose.
(22/5/18) *UPDATE*
It does sometimes cause the sensors to fail on take off and continue to rise beyond 1.2m (thinking it is still on the ground). When it happens I've landed it and taken off again and it is fine, only on occasional takeoff, once it is in the air it is fine for some reason.
May get an update that fits a little nicer underneath, the current version is a little loose.
(22/5/18) *UPDATE*
It does sometimes cause the sensors to fail on take off and continue to rise beyond 1.2m (thinking it is still on the ground). When it happens I've landed it and taken off again and it is fine, only on occasional takeoff, once it is in the air it is fine for some reason.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
