Thingiverse
Max Angel Eye ringlight and mount
von W4YBO
24
Downloads
21
Likes
0
Makes
Designed for mounting and diffusing a 60mm "Angel Eyes" LED ringlight.
Mount the diffuser on the HE280 printhead using 3mm machine screws in the inside corner of the part cooling fans.
On the SeeMeCNC Rostock Max v3, pick 12v off the HE280 circuit board on either side of the screw opposite the heatsink cooling fan. !!! Be careful with polarity. It is marked !!!
Mount the diffuser on the HE280 printhead using 3mm machine screws in the inside corner of the part cooling fans.
On the SeeMeCNC Rostock Max v3, pick 12v off the HE280 circuit board on either side of the screw opposite the heatsink cooling fan. !!! Be careful with polarity. It is marked !!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
