MakerWorld
Vehicles
Go to Model
Maxtrax pin tool
122
Downloads
36
Likes
87
Makes
My maxtrax recovery boards are a bit warped and have seen better days, which means getting four of them onto the mounting pins takes a bit of effort some times.I designed this tool to make it easier to tighten/loosen the pins with one hand while I am hanging off the side of my vehicle, which was getting a bit unsafe in wet/muddy/slippery/icy conditions, especially when reaching over the top of stowed maxtrax to undo the far side ones (if you know, you know). Profile is 100% infill, which makes it very strong. I printed it in PETG but it'd probably be fine in PLA too. It is also a good idea to print it in a bright colour. Save yourself the $20-30 and print this one for the price of the filament, it works well. Please feel free to leave any feedback and even drop some photos of yours in action. Ave Christus Rex
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
