Thingiverse
Mayalaran Shardblade
di ArmoredTale
0
Download
4
Likes
0
Makes
This is the first big model that Patrick made. It's very rough around the crystals because they were booleaned and blender got mad and an attempt was made to fix it. In its current state it prints great. But if you want to remix it, you've been warned! Just kidding, go for it, but that will be a headache. Sorry.
In full it is a bout 6ft long.
For support I used a 5ft x 3/8in alluminum rod. You'll cut off 1 ft for the top section and the 4ft left will got to the hilt up most of the sword. You'll need to shave/sand down the ends a few cm to get the sections snug.
In full it is a bout 6ft long.
For support I used a 5ft x 3/8in alluminum rod. You'll cut off 1 ft for the top section and the 4ft left will got to the hilt up most of the sword. You'll need to shave/sand down the ends a few cm to get the sections snug.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
