Mazda Miata Door Pull (NA)

Mazda Miata Soor Pull (NA)



Porsche-style door pulls for your NA Miata This is a snap-style cap and base that does not require any hardware to hold the cap.



Additional Resources needed:

Adding your color webbing strip for color personalization, the shortest length suggested is 14" as you want enough material to create a loop of 6" and an additional 2" for 1" overlaps for the eye loop to create a little webbing sandwich. Use a 7/8" washer to help keep everything tight.

Use a hot knife or similar tool to create the holes needed in webbing. This will seal the webbing and prevent fraying.



2 ea 7/8" flat washers

36" of color webbing can be bought at most local craft stores



Print settings:

Use PETG or ABS or ASA or stronger material with better heat resistance.

Layer Height: 0.20mm base with variable layer height

Perimeters: 3

Infill: 15% Gyroid

Support: Required