MCD Shade Pull Tab for Paradigm RV

There isn't an available pull tab for the MCD shades in many RVs (mine is an Alliance Paradigm) with the oval shaped bottom. MCD has ones for their lower cost round bottom shades, but not these. This pull-tab makes it easier to pull down the shades, especially if you have the Day/Night shades (the day shade is typically rather hard to get to). The model is reinforced so that you can print this with PLA, though that might get brittle over time. I would recommend using ABS or ASA instead. It's easiest (in my opinion) to put these on from the side of the shade. Note that one of the lobes has a lip that corresponds to the groove in the oval piece. The Original TinkerCad model is available at https://www.tinkercad.com/things/k1FkBTBglpZ-mcd-shade-pull-for-alliance-paradigm for customization.