Thingiverse
MCR Blank Discriminator
von a2grip
1
Downloads
1
Likes
0
Makes
A simple M200 Blank Discriminator for the Fightlite MCR/Shrike, based around MCR Gen 6 geometry this discriminator clips in and uses a trio of small magnets to help prevent accidental feeding of live ammunition into the MCR. The MCR will not top cover will not close on a live round nor will a live round be able to be pulled through the mechanism. The blank discriminator is clearly visible on feed and ejection sides of the weapon with the top cover open or closed.
The design remains untested on Gen 1-5 MCRs but is fully compatible with my 3D printed starter tabs found on my page.
Non M200 blanks such as German DAG 5.56 blanks are likely not compatible with the system
Print as indicated from PETG, ASA or similar high temp polymer and assemble using three 3x5mm rare earth magnets (https://www.amazon.com/dp/B07C6B5MW5) secured with a dab of superglue.
**NOTE: This will not prevent the MCR from feeding a live round via an M4 magazine inserted into the magwell. Always exercise caution and
The design remains untested on Gen 1-5 MCRs but is fully compatible with my 3D printed starter tabs found on my page.
Non M200 blanks such as German DAG 5.56 blanks are likely not compatible with the system
Print as indicated from PETG, ASA or similar high temp polymer and assemble using three 3x5mm rare earth magnets (https://www.amazon.com/dp/B07C6B5MW5) secured with a dab of superglue.
**NOTE: This will not prevent the MCR from feeding a live round via an M4 magazine inserted into the magwell. Always exercise caution and
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
