Thingiverse
ME-109 G2
por A-M-H
115
Descargas
100
Likes
2
Makes
My version of a ME-109 G2
Please be gentle on the historical accuracy of this model.
I wanted to test modeling something with complex curves and lofts in Autodesk Inventor, this certainly was a challenge getting the fuselage correct. I wish I had deepened the panel and control surface lines a little more. I might do so in the next version of this model.
I printed in a couple scales again Chitubox doesn't like just placing models in at the scale I created them in so I had to bump the small one up around 2500% and the large one 5500%.
When printing test fit the prop pin, the base should get glued into the fuselage and the spinner cone should glue to the prop hub, when all that is said and done the prop hub and spinner should spin freely around the prop pin.
Landing gear can be glue up or down... speaking of which I regret that I did not model the tail wheel, but I will in a future update.
Please be gentle on the historical accuracy of this model.
I wanted to test modeling something with complex curves and lofts in Autodesk Inventor, this certainly was a challenge getting the fuselage correct. I wish I had deepened the panel and control surface lines a little more. I might do so in the next version of this model.
I printed in a couple scales again Chitubox doesn't like just placing models in at the scale I created them in so I had to bump the small one up around 2500% and the large one 5500%.
When printing test fit the prop pin, the base should get glued into the fuselage and the spinner cone should glue to the prop hub, when all that is said and done the prop hub and spinner should spin freely around the prop pin.
Landing gear can be glue up or down... speaking of which I regret that I did not model the tail wheel, but I will in a future update.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
