Thingiverse
Meanwell power supply relocation
von Basstronics
52
Downloads
26
Likes
2
Makes
After watching a Teaching Tech video about dual Z I printed the one Michael highlighted in his video. It works, BUT I did not like the plug hanging off the back. I prefer to keep the plug and switch on the side.
You will need (4) M4 x 20mm lg bolts and (4) t nuts.
I posted this as a remix but it was completely redone from the ground up. I found the base where the (4) bolts are to be to skinny and my bolts were bottoming out on the extrusion- so I added a little bit more to it. I also altered a little bit of the geometry here and there. The obvious diffrence was putting the dog house on the right side.
You will need (4) M4 x 20mm lg bolts and (4) t nuts.
I posted this as a remix but it was completely redone from the ground up. I found the base where the (4) bolts are to be to skinny and my bolts were bottoming out on the extrusion- so I added a little bit more to it. I also altered a little bit of the geometry here and there. The obvious diffrence was putting the dog house on the right side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
