Meanwell RS-15 Case

I use this case to hold the 5v power supply for my Raspberry Pi and over 5v accessories to the frame of my printer. This does involve 120v AC power, so if you don't know what you're doing, don't mess with it.


Screws used: M2x6mm for the PSU (look at the datasheet to verify the thread for yours). The holes for attaching the case to the frame of the printer are M3, but the length will change depending on your setup.

I did put rubber grommets in the holes for the cables which holds them in place quite well.


Note: Sadly this is an old design of mine, and it looks like design history was turned off for some reason, so I can't easily go back and edit it before uploading. If I remember correctly, some of the screw holes are a little tight, so you may need to take a drill bit and open them up slightly. (I know the M2 holes are tight, but I'm unsure of the others.)