Measuring cups (fluids)

I needed some measuring cups and was too lazy to run to the store.So i made my own in a few sizes and with spouts.Just fill up up to the bottom of the spout and it'll be the right amount of fluid. Will work for powders also but the results might be inaccurate.I am printing them out of colorless PLA but feel free to use any other material if you want them a certain color, stronger, chemically resistant and so on.They are not marked as the size difference is large enough to just guess and the diameter of them is the same.Made to be printed in vase mode.!!!!! I HIGHLY ENCOURAGE you to spray the inside with clearcoat to seal the print if you aren't sure if you can print watertight prints !!!!!! (I can only recommend it for water if you do not clearcoat it as there is a potential for leaks which may or may not be easy to clean or can potentially be dangerous dangerous)!! 0,6 MM NOZZLE (don't have an 0,8 nozzle yet and 0,4 I think would make them just too weak, slicing them in fo