Mechanical Iris

**V2 : Small improvements go a long way**
Finally had time to finish modeling this project. Surprised at the amount of makes and I feel bad for you guys printing something that was incomplete. To make life easier, I updated 3 parts and added a new part to make the iris, but if you already printed the leafs, you can reuse them with the new parts. Hopefully this will give you guys a better table top piece to show off 3d printing.

**ORIGINAL POST V1**
Saw a diy paper mechanical iris thing online and thought it was pretty cool. I couldn't find this style of iris on thingiverse, so I research different designs and found one that might be 3D printable on instructables.

The trickiest part was getting the leafs printed thin enough plus have a pin on both sides. After a few leaf attempts I got it working fairly well, sadly It can not close all the way. Can't make the thing work any thinner then 0.6mm, maybe a different leaf design will allow it to close and probably use less leafs.