Thingiverse
Medal Display Stand
von BigCope
1
Downloads
3
Likes
0
Makes
Wanted to have a display that would hold a medal like the original but also have space for a plaque (purchased separately from Amazon - 1"x3").
Don't know how to officially remix an existing design, so created measurements and my own design based off the picture/rendering of what was shown in the original (https://www.thingiverse.com/thing:4881198) and created in FreeCAD.
~ 81 grams required
~ 8 hours and 45 minutes of print time
Printed using Sidewinder Artillery X1 with Cura slicer.
Cura set on Dynamic Quality (0.16mm resolution) with a 20% Cubic infill pattern.
Don't know how to officially remix an existing design, so created measurements and my own design based off the picture/rendering of what was shown in the original (https://www.thingiverse.com/thing:4881198) and created in FreeCAD.
~ 81 grams required
~ 8 hours and 45 minutes of print time
Printed using Sidewinder Artillery X1 with Cura slicer.
Cura set on Dynamic Quality (0.16mm resolution) with a 20% Cubic infill pattern.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
