Medical Face Shield V2

I uploaded new versions of each piece with minor changes on 2020-04-05. Low cost, fast (80-90 min) printed parts for a lightweight medical face shield. Fits over glasses. image shows an MD with shield, goggles and mask. MDs have picked up over 100 so far for covid-19.
Only other parts needed are 8.5x11" overhead transparency film and hair elastic.
Standard 3 hole punch the transparency film.
Skinny parts make sticking to the plate touchy. Adjustments likely needed with change of filament.
1 or 2 units fit on MK3S and 1 on Mini.
Make extra washers since they are fiddly and easy to lose.

Choices of use in declining order: 1- dispose after single use, 2- replace the film, 3- don't use for 4 days, 4- wipe down with alcohol. Reuse immediately only if you have to. PLA and PETG melt in an autoclave.
I have made 100 so far for Canadian MDs. They like them and are distributing them rather than disposing.

Offer shields to your local clinic, doctor's office, hospital, grocery sto