Thingiverse
Medieval Torch Light
por DougLeary
43
Descargas
46
Likes
0
Makes
This medieval-looking torch light fixture is designed for an animated flame bulb. The two main printed parts are the Base and the Cone, which twist-lock together. Drain holes in the base prevent water from collecting in the cone. The base is designed to mount on the end of a piece of 3/4" metal electrical conduit, because that's what I had lying around.
About heat and PLA - This torch has been outside for a couple weeks, with the bulb running about 6 hours/night. No deformation at all. The bulb just doesn't get warm enough to cause a problem. Since it's a Halloween decoration it will be put away during the summer. If you leave it out in hot weather please let me know how it does.
**Extras:**
Snap-in Grommet for bringing the cord out through a hole in the side of the pipe.
Elbow for mounts made of multiple pieces of conduit.
Bracket to attach conduit to a wall.
About heat and PLA - This torch has been outside for a couple weeks, with the bulb running about 6 hours/night. No deformation at all. The bulb just doesn't get warm enough to cause a problem. Since it's a Halloween decoration it will be put away during the summer. If you leave it out in hot weather please let me know how it does.
**Extras:**
Snap-in Grommet for bringing the cord out through a hole in the side of the pipe.
Elbow for mounts made of multiple pieces of conduit.
Bracket to attach conduit to a wall.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
