Thingiverse
Medium Lightweight Bookend
par MagicSmokeSTAT
98
Téléchargements
91
Likes
2
Makes
Medium-sized lightweight bookend inspired by xyzaxis's Lightweight Bookend.
Similar design ideas as xyzaxis's bookend: simple, low-filament usage, thin part that goes under books.
The bottom of the vertical portion is not attached to the bottom, which removes a strain point where it would otherwise fail under heavier load.
Prints with a small brim at the skinny end to decrease the chance of peeling off the bed; use a nail-clipper to clip it off after printing. Suggest using a high-adhesion bed like PEI.
Similar design ideas as xyzaxis's bookend: simple, low-filament usage, thin part that goes under books.
The bottom of the vertical portion is not attached to the bottom, which removes a strain point where it would otherwise fail under heavier load.
Prints with a small brim at the skinny end to decrease the chance of peeling off the bed; use a nail-clipper to clip it off after printing. Suggest using a high-adhesion bed like PEI.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
