Thingiverse
Mega Flow 200mm Fan Adapter
por kwagmier
12
Descargas
4
Likes
0
Makes
Cooler Master 200mm Mega Flo to standard 200mm fan mount adapter.
I had the unfortunate luck of buying the wrong fan to fit my case, problem solved.
197.894mm x 197.8954mm x 3.6183mm
~2 hour print on an Ender3
My print snapped at the wiring indent while pulling it off the print bed, may want to use the BRIM option to give it some extra support when removing it. And remove after mounting it to the fan, but before the case. The torque from threading the screws in may add undo stress causing a failure.
The design uses standard fan screws to attach the bracket to the fan, and then on to the case. Advise on going slow when screwing into the bracket to prevent
I had the unfortunate luck of buying the wrong fan to fit my case, problem solved.
197.894mm x 197.8954mm x 3.6183mm
~2 hour print on an Ender3
My print snapped at the wiring indent while pulling it off the print bed, may want to use the BRIM option to give it some extra support when removing it. And remove after mounting it to the fan, but before the case. The torque from threading the screws in may add undo stress causing a failure.
The design uses standard fan screws to attach the bracket to the fan, and then on to the case. Advise on going slow when screwing into the bracket to prevent
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!